To open previously created screen data
Question
I was saving data created with Screen Creator 5 (SC5) to a USB memory.
I would like to open this screen data on the computer I am currently using.
The screen data is located in a folder named “ABC”. (Only folder data, no ABC.PRO)
What should I do?
Answer
Please try the steps below.
1.Start SC5.
2.Proceed to Project -> Create New and create a new project called “ABC”.
At that time, please select the panel type.
On the connected device tab, select the PLC if it is connected but the PLC is known.
3.Once you have created the project, close SC5.
4.Open the folder where SC5 was installed. (usually C:\SC5)
5.Open the ABC folder in the SC5 folder.
6.Temporarily delete the contents of the ABC folder.
7.Copy the contents of the ABC folder on the USB memory to the ABC folder.
8.Start SC5 and open project ABC.
9.Check the screen using the “Screen” menu.
Inquiry
Click here for inquiries by email