The Z-axis waveform data

Posted01/27/2022

Updated11/17/2023

Bysales-eng

Question

I tried displaying the waveform with OnSinView2, but the Z-axis data is only displayed on the plus side.
The other axes oscillate have amplitudes based on 0m/s2.

Answer

We think this is because the sensor was installed with the printed side facing up.
In this case, the Z-axis is based on Earth’s gravity +1G, and the amplitude vibration is measured based on +1G (9.8m/s2).

Inquiry

technical support

Click here for inquiries by email