How Can We Help?
Terminal block set signal name/compatible wire
Question
I would like to use the CN1 terminal block set.
Please tell me the signal name of the terminal block and the applicable wire.
Also, please tell me the signal name of the 2P green terminal block.
Answer
The upper left of the CN1 terminal block set is 1, and the lower right is 50.
Click here for details
Applicable wire is AWG12 to 24, stripping allowance is 7 to 8mm.
The recommended tightening torque for the terminal block screws is 0.5N.m.
The 2P green terminal is the connector shell of the cable that connects to the servo driver.
Inquiry
technical support
Click here for inquiries by email
Click here for inquiries by email